How To Cut Plasterboard

Cutting plasterboard isn’t as hard as you may think and you only need a small selection of tools to get a quick clean cut.

The essential tools you will need are a tape measure, pencil, sharp cutting knife and a spirit level or straight edge. Some other tools that are also useful are as follows:

  • A jab saw or multi tool for cutting holes
  • A fine tooth handsaw for certain cuts
  • A rasp for making smooth edges

Plasterboard is a made of gypsum and has a paper covering. Follow the steps below to make your cut:

  1. The first step to cutting plasterboard is to measure and mark the cut you want to make, we always recommend double checking your measurement before cutting.
  2. Place your spirit level or straight edge along the marked line and make a score with your knife about 3mm deep.
  3. Lift the plasterboard sheet off the ground and snap/bend the board back along the scored line, the plasterboard will not come apart yet as it will still be held together by the paper backing.
  4. Cut the paper backing with your knife and the pieces will come apart.

You can optionally smooth the edges of the plasterboard with a rasp giving a neater finish.

To cut holes in plasterboard a jab saw is ideal, mark the cut with your tape measure and pencil and then stand the plasterboard up and push the jab saw through. Make sure there is nothing behind the plasterboard where you will be pushing through, especially you, for example make sure you are not holding the plasterboard directly behind the hole you are cutting.

To cut an L shape, mark the cut with your pencil and tape measure and then use a handsaw to cut the smaller side. Once cut use the above cutting method to cut and split off the remaining line/cut.